# Knife Grind Calculator: Flat, Hollow, Convex and S Grinds

> Work out a knife grind before you grind it: bevel angles, thickness behind the edge, fuller depth and web for an S grind, and the wheel height to set. Then mark the lines on a template and print them at 1:1.

Source: https://knifetemplates.com/grinds

## How the numbers work

The section is drawn square to the edge, spine up, and every height is measured from the edge. Angles are per side, from the blade's centre plane (or from the flat back of a chisel grind): the arctangent of half the thickness change over the height it happens in.

### The cutting edge

What the grinder leaves and what the stone does are separate. The grind ends at a thin land, the edge left; the stone then cuts one flat bevel per side at its angle, down to a sharp apex, and stops where it meets the grind. That is the same for every grind, so the same knife sharpened at the same angle gets the same edge whether it was ground flat, hollow, convex or S. The edge drawing is magnified the same way in both directions, so its angles are the real ones; the stretched section makes every angle look steeper than it is.

The drawing marked 1:1 is the section at actual size. On a screen its size is the browser's idea of a millimetre, so check it against the 10 mm bar; the printed sheet carries the section at exactly 1:1.

### The fuller

A fuller ground on a wheel is an arc of that wheel. Its depth for a width w on a radius r is r − √(r² − (w/2)²). A wider fuller on the same wheel is deeper; a smaller wheel cuts deeper for the same width. The belt adds its thickness to the radius.

The web is judged at its thinnest. On a flat bevel that is not at the deepest point of the fuller, the nadir: the face below the nadir was already thinner, so the thinnest steel sits a little lower, level with the wheel's apex.

A beginner is safer keeping each fuller to a quarter of the thickness where it goes, which leaves half the steel as web. Practised makers go to a web under 1 mm, down to about 0.6 mm.

### Setting the wheel

With the edge on the table and the blade against a fence, the height to set is the wheel's apex above the table. It is not the nadir's height: the bevel leans, so the wheel first touches it higher than its apex, by the radius times the sine of the lean. On a 200 mm wheel and a typical kitchen bevel that is about 2.5 mm; on a large radius platen it is ten or twenty. The setup drawing shows both.

Holding the blade a few degrees off square to the belt helps it follow a curved edge. It sweeps the wheel's corner along the blade, which cuts a fuller shallower by the cosine of that angle: about 3% at 15°.

### Along the knife

The lines are scribed a fixed distance from the edge, measured square to it, because the edge rides the table while the fuller is ground. The blade gets lower and, with a distal taper, thinner towards the tip, so a fuller that suits the heel can break through further along. The strip under the knife shows the web at every station. Grind the fullers before the distal taper.

### Convex grinds

A convex grind is ground as flat facets and blended. The drawn blend is the curve that keeps each facet's middle and rounds off its corners, which is a fair picture of what a slack belt does but not a measurement. The blend angle given for each corner is halfway between the facets either side of it: a starting point for the slack belt.
