# Printing at actual size

> How to print a knife template at actual size on A4 or US Letter: turn off scaling, check the 100 mm ruler, join the sheets, and get it onto steel.

Source: https://knifetemplates.com/guides/print-at-actual-size

[Learn](https://knifetemplates.com/guides) / Printing & stock

The outline can look perfect on screen and still come out of the printer a little smaller than you meant. I would make measuring the ruler part of every print, before spending any time getting the paper onto steel.

[Knife Templates](https://knifetemplates.com/makers/knife-templates) · 3 min read

![One A4 sheet of the Santoku 165 template as it prints, with the 100 mm check ruler along its foot](https://knifetemplates.com/template-images/santoku-165-5-sheets.svg)

## Printer settings

Choose Actual size or 100% in the print dialog. Fit to page can enlarge or reduce a drawing to the printable area, while Shrink to fit can reduce an oversized page.

Match the paper size and orientation to the sheets you generated, then look at the preview. If the ruler or seam line is clipped, give the printer more safe margin. Keep the print scale at 100%.

## Check the ruler

There is a 100 mm ruler along the bottom of each sheet. Put a steel rule or calipers against it and check that it really is 100 mm.

If the ruler is wrong, go back to the print settings. I would keep the design at the dimensions you want instead of changing it to compensate for a printer setting.

## Join the sheets

A longer knife can run over several sheets. They are numbered and labelled at each seam. Trim or overlap as the seam label indicates, line up where the drawing continues across the seam, and tape the pages from the back.

If you prefer to overlap and glue the paper, choose overlap in the print settings first. That leaves the extra strip for the join.

## Put it on the steel

Once you are happy with the print, you can stick it down or trace the outline with a scribe. Glue can wet and stretch paper a little, makes it easy to rip.

Have a last look at the tang, holes and overall fit on the stock. This is the easy point to notice that a pin needs moving or a handle needs more room.

## What a small scaling error does

If the 100 mm ruler measures 97 mm, the print is at 97% scale. A 210 mm blade would come out about 203.7 mm long. The same shrinkage affects the handle and hole spacing, so changing just the blade length in the editor cannot repair the whole drawing.

Check the paper size at both ends: the sheets generated by the editor and the paper selected in the print dialog. A4 and Letter are different sizes. Printing one onto the other with a fitting option can scale the drawing or clip its edges.

*Print problems to fix in the settings*

| What you see | What to check |
| --- | --- |
| 100 mm ruler measures 96–98 mm | Fit, Shrink or a browser printable-area scaling option. Select Actual size or custom 100%. |
| Right scale, clipped marks | Printer margins and paper size. Increase the editor’s safe margin. |
| Paper size changed during PDF printing | The PDF’s page size and the selected printer paper. Keep scaling off and regenerate for the actual paper if needed. |

[Next up Fitting blanks on a bar Putting a batch of blanks on one bar, with enough room to cut them out and know the offcut that will be left.](https://knifetemplates.com/guides/stock-nesting)

## Related guides

- [Editing a template in the browser](https://knifetemplates.com/guides/editing-a-knife-template)

## Put it into practice

[Choose a template](https://knifetemplates.com/templates) [Arrange blanks on stock](https://knifetemplates.com/nest)
