# Heat treating knives in a salt pot

> What a salt bath furnace does differently, what it is good and bad at, the steels it was tested on, and the safety rule that matters most.

Source: https://knifetemplates.com/heat-treating/in-a-salt-pot

[Learn](https://knifetemplates.com/guides) / [Heat treating](https://knifetemplates.com/heat-treating)

Molten salt heats steel quickly and keeps the air off it. It also asks for more respect than a furnace does.

[Knife Templates](https://knifetemplates.com/makers/knife-templates) · 2 min read

## What it is and what it gives

A salt pot heats steel in molten salt. The advantages are that you do not need to protect the steel from oxygen, and liquid is much better at transferring heat than air, so blades come up to temperature faster.

## The limits

Specific salts are used for different temperature ranges, and molten salts for stainless or high speed steels need different salts again. The verdict is that salt bath furnaces suit only those using a narrow range of steel types. The testing covered 1084, 52100 and O1, and did not cover stainless or high speed steels.

## The safety rule

Water and molten salt do not mix. "If you drop significant amounts of water into the salt bath it could explode and you would be in significant danger." Wear "protective equipment such as a face shield and long sleeves," and keep every wet thing, including cold tongs and blades, away from the pot.

## Where this comes from

- [Introduction to Knife Steel Heat Treating from a Metallurgist](https://knifesteelnerds.com/2024/09/17/introduction-to-knife-steel-heat-treating-from-a-metallurgist/), Knife Steel Nerds. The stages, equipment, datasheets and what to do when datasheets disagree. Larrin Thomas’s own recommendations; it gives no schedule for a particular steel.
- [Rapid Heat Treating with Salt Pots](https://knifesteelnerds.com/2024/08/05/rapid-heat-treating-with-salt-pots/), Knife Steel Nerds. One salt bath furnace and a few steels. Stainless and high speed steels were not tested.

[Next up Sending knives out to be heat treated When to send it out, how factory and custom heat treating compare, and what to ask.](https://knifetemplates.com/heat-treating/sending-it-out)

## Keep reading

- [Heat treating knives in an electric furnace](https://knifetemplates.com/heat-treating/in-a-furnace)
- [Foil or coatings: protecting knife steel](https://knifetemplates.com/heat-treating/protecting-the-steel)
- [Heat treating knives in a forge](https://knifetemplates.com/heat-treating/in-a-forge)
- [Knife steel: 52100](https://knifetemplates.com/steel/52100)
- [All heat treating pages](https://knifetemplates.com/heat-treating)

## Put it into practice

[Choose a template](https://knifetemplates.com/templates) [Read the print guide](https://knifetemplates.com/guides/print-at-actual-size) [Arrange blanks on stock](https://knifetemplates.com/nest)
