Learn / Steel

Knife steel: 5160

5160 often comes up when makers talk about tough working blades. I would start with identified bar and a repeatable schedule rather than an unknown spring with years of service behind it.

Knife Templates · 2 min read

What it is

5160 is a low alloy steel known for its excellent toughness. It is used by many forging bladesmiths for its good properties, and it is common in the form of leaf springs. It is not stainless.

What the testing found

In Charpy tests on 2.5 x 10 x 55 mm specimens without any notch, 5160 was better than any other steel apart from 8670. The best result came from a process of its own: austenitizing at 1500-1525°F and tempering at 375-400°F gave the best combination of properties, with a quench in Parks 50 oil followed by 15 minutes in liquid nitrogen.

The window is narrow: tempering above 400 or below 375°F is not recommended. It is also a choice for big work, since 8670 and 5160 are good choices for large knives that need very high toughness.

Where to be careful

That optimum belongs to a process that included liquid nitrogen. The worked route on this site is a different one, from a supplier sheet, and the two should not be mixed: keep the hardening temperature, quench, cold step and temper together from one source. The route page says more.

If you cannot identify a recycled spring, treat it as experimental stock rather than calling the knife 5160.

Where this comes from

Next upKnife steel: 52100A non-stainless bearing steel with good toughness and a fine edge.

Comments

Questions, corrections and what worked for you. Upvote comments you find useful.

Loading comments…

Knife Templates