Learn / Steel

Knife steel: 52100

52100 rewards a little attention to what happened before the final hardening heat. I would keep the whole process together here, including the anneal, rather than copy the last two temperatures from somebody's notes.

Knife Templates · 2 min read

What it is

A non-stainless bearing steel used for fine cutting blades. The chromium in it does not make it stainless. Known bar makes the starting point clearer than an unidentified bearing race.

What the testing found

52100 shows good toughness compared with other low alloy steels, and it has medium hardenability, so it straddles the line between water or fast oil and medium oil. The tested route is to austenitize at 1500-1525°F for 15 minutes and quench in fast oil, then temper between 300 and 400°F, the lower end for higher hardness and the higher end for better toughness.

The testing places it above its neighbours: 52100 over 1095 or O1 on toughness, and 52100 and CruForgeV are good for general purpose knives. In forge heat treating it is also the pick among the fine-cutting steels.

Where to be careful

The tested process is not claimed to be the absolute best possible heat treatment. A cryo step can add about 0.5 Rc for applications that need maximum strength, at a small toughness cost. It is not stainless, so treat it like the other carbon steels and keep it dry.

Where this comes from

Next upKnife steel: O1An oil-hardening tool steel that needs a long, controlled soak.

Comments

Questions, corrections and what worked for you. Upvote comments you find useful.

Loading comments…

Knife Templates