Learn / Steel

Knife steel: 80CrV2

80CrV2 is a popular choice for working knives. The detail I would pay most attention to is how the bar was supplied, because its starting structure changes how it hardens.

Knife Templates · 2 min read

What it is

80CrV2 has 0.80% carbon, just like 1080, with 0.5Cr and 0.4Mn where 1080 has 0.75Mn. The V in the name is vanadium. It is not stainless.

80CrV2 and 1080 compared
CarbonOther
80CrV20.80%0.5Cr-0.4Mn, with vanadium
10800.80%0.75Mn

What the testing found

Toughness: "80CrV2 has quite good toughness; I have found slightly better toughness than 1084, in fact." Hardenability: "So 80CrV2 has reasonably good hardenability," and "With a fine carbide structure it will fully harden even with 1/4″ stock quenched in slow oil."

Edge retention is the other side: "its wear resistance as measured by a CATRA edge retention test is very low on the chart." That is the trade it offers: good toughness and hardenability, and not much edge life.

It has a practical place: it is relatively inexpensive and used by many forging bladesmiths. Forge testing puts it with 1084 as best for general purpose knives.

Where to be careful

The tempering limit is explicit: do not temper 80CrV2 above 450°F, and the 300°F temper looks attractive for thin knives with high cutting performance. Austenitising was 1525°F for 10 minutes, longer for stock thicker than 1/8″.

Datasheets disagree about 80CrV2 more than most: virtually every one recommends something different. The route on this site is the one from the independent tests.

Where this comes from

  • How to Heat Treat 80CrV2, Knife Steel Nerds. Larrin Thomas’s tests of 80CrV2, with datasheet comparisons. Test coupons were sealed in stainless foil.
  • How to Heat Treat Knife Steel in a Forge, Knife Steel Nerds. A method for reducing forge error, tested on seven low alloy steels. The author still recommends a furnace or a professional for most people.
  • Introduction to Knife Steel Heat Treating from a Metallurgist, Knife Steel Nerds. The stages, equipment, datasheets and what to do when datasheets disagree. Larrin Thomas’s own recommendations; it gives no schedule for a particular steel.
  • How to Heat Treat 80CrV2, Knife Steel Nerds. Original experiments by metallurgist Larrin Thomas. Starting microstructure, hold and quench stay together. Do not transfer experimental property values to a different process.
Next upKnife steel: 5160A low alloy spring steel known for toughness, with a narrow tempering window.

Comments

Questions, corrections and what worked for you. Upvote comments you find useful.

Loading comments…

Knife Templates