Learn / Steel

Knife steel: 1095

1095 is familiar, but I would not pick it just because the name sounds simple. The quick transfer and fast quench deserve as much attention as the temperature.

Knife Templates · 2 min read

What it is

1095 is a simple carbon steel with 0.95% carbon and small amounts of Mn and Si. Like 1084 it is not stainless, so it rusts if left wet.

What the testing found

The finding to know: O1 and 1095 both showed relatively low toughness in earlier testing, likely because of plate martensite. The recommendation follows from it: 52100 over 1095 or O1 on toughness testing.

Plenty of makers like 1095 and make good knives from it, and a well-heat-treated blade is a good knife. The point is that the margin for error is smaller than the name suggests. In the forge testing, 1095 is on the list for fine cutting knives like kitchen knives, with 52100 the pick of the three.

What it asks of the maker

It needs a fast quench, which is why the route here names Parks 50. Oil testing makes the general point: if you buy only one oil, make it a fast oil like Parks 50 so that you can quench the low hardenability steels.

Where this comes from

Next upKnife steel: 80CrV2A low alloy steel with good toughness and hardenability, but low wear resistance.

Comments

Questions, corrections and what worked for you. Upvote comments you find useful.

Loading comments…

Knife Templates