Learn / Steel

Knife steel: 1084

If I were setting up for an early carbon-steel build, 1084 would be on the shortlist. It asks the least of you, though it still asks for a controlled heat and a proper quench.

Knife Templates · 2 min read

What it is

In the SAE numbering, the 10 means a plain carbon steel and the last two digits are the carbon in hundredths of a percent, so 1084 is about 0.84% carbon. Actual bars vary within a range, so the number is a guide, not a guarantee.

It is not stainless. It will rust if it is left wet, and it takes a protective finish and a drying habit.

What the testing says about it

What the testing says about 1084 is scattered through articles on other steels, and it is useful. For makers who heat treat with a torch or an uncontrolled forge, the fallback is 1075/1084. In forge testing, 1084 and 80CrV2 came out best for general purpose knives.

On toughness, 80CrV2 tested slightly better than 1084. 1084 is also among the steels that avoid plate martensite, which is linked to the low toughness found in 1095 and O1, so choosing steels like 52100, 1084 and 80CrV2 is a cheaper and simpler way around the problem.

Where I would hesitate

The sources I could stand behind say less about 1084 than about the steels above, so I would not read more into it than that. The worked route on this site comes from a supplier sheet, and that sheet needs the cross-check described on the route page. If you can get the producer's datasheet for your bar, use it as well.

Where this comes from

  • How to Pick the Best Steel for Every Knife, Knife Steel Nerds. Larrin Thomas’s method for choosing a steel, with his own recommendations. Opinion informed by his testing; the charts are images.
  • How to Heat Treat Knife Steel in a Forge, Knife Steel Nerds. A method for reducing forge error, tested on seven low alloy steels. The author still recommends a furnace or a professional for most people.
  • Bainite Heat Treatments of 52100, O1, and 1095: How Much Toughness?, Knife Steel Nerds. Austempering experiments and what they say about plate martensite in 1095 and O1. A different route from quench and temper.
  • How to Heat Treat 80CrV2, Knife Steel Nerds. Larrin Thomas’s tests of 80CrV2, with datasheet comparisons. Test coupons were sealed in stainless foil.
  • 1084 Heat Treat, July 2020, New Jersey Steel Baron. Supplier schedule for controlled equipment. Fahrenheit is authoritative where the PDF prints an inconsistent Celsius conversion. Example setpoints below sit inside its ranges; no hardness is guaranteed.
Next upKnife steel: 1095A simple high-carbon steel with lower toughness than its reputation suggests.

Comments

Questions, corrections and what worked for you. Upvote comments you find useful.

Loading comments…

Knife Templates