Learn / Steel

Knife steel: S35VN

S35VN is a well-rounded powder metallurgy stainless steel. It does not win any one category, which is not a criticism.

Knife Templates · 2 min read

What it is

S35VN was developed and produced by Crucible Industries and released in 2009, as a modification of S30V with less vanadium, 0.5% niobium added and the nitrogen addition removed. The changes led to improved toughness and machinability relative to S30V at the cost of some edge retention. The overall picture is even-handed: good potential hardness, toughness, edge retention and corrosion resistance. It does not particularly excel in any one category, though it is not terrible in any of them either.

CPM S35VN typical composition (producer data sheet, as published by a distributor)
ElementContent
Carbon1.40%
Chromium14.00%
Vanadium3.00%
Molybdenum2.00%
Niobium0.50%

What the testing found

It reaches hardness: "S35VN has good potential hardness; it is capable of reaching at least 64 Rc." It is tougher than its relatives: "It also has better toughness than S30V, S45VN, and Elmax." Against Vanax, "S35VN does very well, being similar to Vanax at a similar hardness. Vanax has an advantage for corrosion resistance while S35VN has the advantage in terms of potential hardness."

On corrosion it rates 7.8 out of 10, similar to Elmax (7.8) but not as good as S45VN (8.4), M390 (9.1) or Vanax (10). That is a rating from one set of testing, so treat it as one judgement.

Edge retention, with a caveat

The numbers disagree. The datasheet lists S35VN and S30V both at 145% of 440C, with an asterisk on S35VN: "Estimate based upon market feedback." A Bohler-Uddeholm CATRA study found approximately 132% compared with 149% for S30V, both tested at 61 Rc, and the 132% value looks most accurate for S35VN.

Where to be careful

The tested route and the producer's differ, as the route page sets out. And toughness specimens made by another maker came out about 1 Rc softer than the original with the same heat treatment, so compare your own readings, not the published ones.

Where this comes from

  • S35VN Steel: Properties and How to Heat Treat, Knife Steel Nerds. Larrin Thomas’s tests of S35VN with datasheet comparisons. His route is hotter than the producer’s. The charts are images, so this site quotes only the text.
  • CPM S35VN data sheet, Niagara Specialty Metals. The CPM S35VN data sheet as published by a distributor of Crucible’s CPM steels; Crucible’s own copy was not reachable. Producer data, not independent testing, and a different route from Larrin Thomas’s.
  • CPM MagnaCut data sheet, issue 1, March 2021, Crucible Industries. The producer’s own composition, toughness, edge retention, annealing and heat treatment figures. Producer data, not independent testing.
Next upKnife steel: CPM-154A well-rounded powder metallurgy stainless steel, easy to finish, with a toughness result that is still unexplained.

Comments

Questions, corrections and what worked for you. Upvote comments you find useful.

Loading comments…

Knife Templates