What it is
A fine-carbide stainless steel. Stainless still needs cleaning and drying, and a completed heat treatment and finish are part of the corrosion performance you expect. The supplier sheet warns that tempering at 800°F (425°C) and above "will result in reduction of toughness and corrosion resistance."
| Element | Content |
|---|---|
| Carbon | 0.65% |
| Chromium | 12.8% |
What the testing found
AEB-L and 14C28N are the best in the high toughness group, and for hard use knives a high toughness steel like 8670, Z-Tuff or AEB-L is the better choice. The trade-off is edge retention: AEB-L is similar to 52100, which is significantly lower than higher carbide content stainless steels, and at 64 Rc it has both lower toughness and lower edge retention than MagnaCut at 61 Rc.
Nitro-V, which has "the same C, Cr, and Si along with a minor difference in Mn," has "slightly lower toughness than AEB-L for unknown reasons."
Know which steel you have
Cold treatment testing found that one of the major knife steel suppliers sells Buderus X65Cr13 as AEB-L, and it needed about 50°F higher austenitizing temperatures for the same hardness as Uddeholm AEB-L. If you are buying bar sold under the name, ask the supplier which one it is, because the hardening temperature on the route page is for the supplier's sheet, not for either of these two steels in particular.
What the route asks of the maker
A furnace that holds about 1066°C (1950°F), correctly rated foil, aluminium quench plates with compressed air, and a managed sub-zero treatment. A household freezer does not reproduce a dry ice bath, and liquid nitrogen is preferred. The route page covers each.
Where this comes from
- Knife Steels Rated by a Metallurgist: Toughness, Edge Retention, and Corrosion Resistance, Knife Steel Nerds. One metallurgist’s ratings, which he says he may change. The rating tables are images, so this site quotes only the text.
- How to Pick the Best Steel for Every Knife, Knife Steel Nerds. Larrin Thomas’s method for choosing a steel, with his own recommendations. Opinion informed by his testing; the charts are images.
- Nitro-V: Its Properties and How to Heat Treat It, Knife Steel Nerds. Larrin Thomas’s tests of Nitro-V against AEB-L and 14C28N, with his heat treatment recommendation. The composition table is an image, so none is given here, and I found no producer datasheet. He says edge retention and corrosion resistance still need testing.
- Dry Ice vs Liquid Nitrogen vs Freezer: How Cold Do You Need for Cryo?, Knife Steel Nerds. Freezer, dry ice and liquid nitrogen compared, on a few steels. The author notes the steel sold to him as AEB-L was not Uddeholm AEB-L.
- AEB-L Heat Treat, July 2020, New Jersey Steel Baron. Supplier schedule for controlled equipment. Fahrenheit is authoritative where the PDF prints an inconsistent Celsius conversion. Example setpoints below sit inside its ranges; no hardness is guaranteed.
- UHB Stainless AEB-L data sheet (undated scan), Uddeholm. The producer’s own sheet for the strip steel, as a scan hosted by Knife Steel Nerds. It is undated, I found no current producer sheet, and it gives hold times only as a graph. Producer data, and a different route from the supplier’s.
Comments
Questions, corrections and what worked for you. Upvote comments you find useful.
Loading comments…