Learn / Steel

Toughness, edge retention and corrosion resistance

Every steel comparison comes down to the same three words. They are measured differently, they trade against each other, and none of them is more important than the knife's shape.

Knife Templates · 2 min read

How each is measured

Toughness here is measured with a Charpy test, a subsize, unnotched one with 2.5 x 10 x 55 mm specimens. Edge retention is measured with CATRA, which measures abrasive wear of knives. Those are specific tests, and a figure from one is not a figure from another.

Hardness is a third thing, and the HRC number does not tell you either of the others on its own. That has its own guide.

The trade-offs

"Usually more of one means less of the other." On carbide, "In general, more carbide means lower toughness but higher edge retention." And "There is no such thing as a steel that is a '10' in both toughness and edge retention."

Corrosion resistance has its own trade: "there is a trend where more corrosion resistant steels typically have a lower maximum hardness."

Choosing

"Instead, selecting a steel is about prioritizing the categories." For one job, "For hard use knives it is better to use a high toughness steel like 8670, Z-Tuff, and AEB-L." Which categories matter depends on the knife. A kitchen knife that is washed and dried asks different things of the steel from a chopper that is dropped in mud.

What steel cannot do

A great steel and heat treatment can't save a bad design, and the heat treatment can only do so much. The shape of the edge and how the knife is sharpened account for a lot of what people credit to the steel.

On ratings

Ratings articles are common, and the advice from the metallurgy sources is to ignore them; even the ratings published with the testing carry a reservation that they may change with new information. I treat them as one metallurgist's judgement, so this site does not rank steels.

Where this comes from

Next upCarbon, stainless, tool and powder metallurgy steelsThe steel families and what each asks of the maker.

Comments

Questions, corrections and what worked for you. Upvote comments you find useful.

Loading comments…

Knife Templates