What it is
Carpenter describes its D2 as "an air hardening, high-carbon, high-chromium tool steel." It has been a mainstay in knives for decades, and in recent years it has been popular in budget production folders.
It is not stainless. With about 12% chromium, the high carbon content means many chromium carbides form, so the chromium is tied up. Carpenter says only that the chromium gives "mild corrosion resisting properties in the hardened condition."
| Element | Content |
|---|---|
| Carbon | 1.50% |
| Chromium | 12.00% |
| Vanadium | 0.90% |
| Molybdenum | 0.80% |
| Manganese | 0.50% |
| Silicon | 0.30% |
What the testing found
The source article covers conventional D2 and two finer-grained versions of the same composition. The finer carbide structure of PSF27 gives superior toughness against conventional D2, and the yet finer structure of CPM-D2 gives better toughness than either. In one comparison, PSF27 at 64 Rc had higher toughness than conventional D2 at 60 Rc.
Against the stainless alternatives: "Ditto for conventional D2 and 154CM, they have similar toughness and edge retention but 154CM is stainless." On edge retention and cold treatment, "a comparison I made between a 36 hour cryo and no cryo D2 at similar hardness led to no difference in edge retention."
Finishing is easier than the carbide content suggests: "Both have primarily chromium carbides making finishing and sharpening relatively easy with aluminum oxide abrasives and stones."
Where to be careful
Keep the hardening heat in check: restrict austenitizing temperatures to no higher than 1900°F in most cases unless maximum hardness is necessary. The producer's sheet describes a different route from the tested one, so do not mix them: that comparison is on the route page.
Where this comes from
- How to Heat Treat D2, PSF27, and CPM-D2, Knife Steel Nerds. Larrin Thomas’s tests, mostly on PSF27, with one recommended route for all three because they share a composition. The article states no composition; the figures on this site come from Carpenter’s data sheet.
- CarTech No. 610 (D2) data sheet, Carpenter Technology. The producer’s own nominal composition, annealing and hardening figures for D2. Producer data, and a different route from Larrin Thomas’s: it hardens at 1800 to 1875°F and quenches in air.
- What is the Future of Stainless Knife Steel Design?, Knife Steel Nerds. Why chromium makes steel stainless and why chromium carbides get in the way.
Comments
Questions, corrections and what worked for you. Upvote comments you find useful.
Loading comments…