What it is
Nitro-V is a stainless steel sold by New Jersey Steel Baron, first released in 2017 and designed as a version of Uddeholm AEB-L modified with nitrogen and vanadium. It looks very similar to AEB-L, with the same C, Cr and Si and a minor difference in Mn, and its nitrogen content is the same as 14C28N. The composition table in the source article is an image, and I found no producer datasheet, so I give no figures.
What the testing found
"Nitro-V has very good toughness compared with other steels. It has slightly lower toughness than AEB-L for unknown reasons. It is significantly tougher than the powder metallurgy stainless steels like M390, Elmax, and S35VN. Therefore Nitro-V would be well suited to knives requiring good toughness." It reaches about 64 Rc at peak hardness, similar to AEB-L, with a slightly lower best austenitising temperature.
Edge retention and corrosion
Both are expectations, not results. On edge retention: "Nitro-V is expected to have very similar wear resistance and edge retention to AEB-L, but there has not been any testing to confirm that," and AEB-L "has edge retention similar to 52100, which is significantly lower than higher carbide content stainless steels like 440C, CPM-154, S30V, etc."
On corrosion, the nitrogen did not do what you might hope for chromium: it did not increase chromium in solution for enhanced corrosion resistance. The nitrogen may itself increase corrosion resistance somewhat relative to AEB-L, and 14C28N has significantly more chromium in solution, which likely gives it better corrosion resistance than Nitro-V and AEB-L. The source article ends by saying more corrosion and edge retention testing is needed.
Where to be careful
The tempering limit is firm: do not go past 350°F on the evidence, because the 450°F temper reduced both hardness and toughness unexpectedly. And the source article does not say which AEB-L it compares with; steel sold as AEB-L can be Buderus X65Cr13, which behaves a little differently.
Where this comes from
- Nitro-V: Its Properties and How to Heat Treat It, Knife Steel Nerds. Larrin Thomas’s tests of Nitro-V against AEB-L and 14C28N, with his heat treatment recommendation. The composition table is an image, so none is given here, and I found no producer datasheet. He says edge retention and corrosion resistance still need testing.
- Dry Ice vs Liquid Nitrogen vs Freezer: How Cold Do You Need for Cryo?, Knife Steel Nerds. Freezer, dry ice and liquid nitrogen compared, on a few steels. The author notes the steel sold to him as AEB-L was not Uddeholm AEB-L.
- Knife Steels Rated by a Metallurgist: Toughness, Edge Retention, and Corrosion Resistance, Knife Steel Nerds. One metallurgist’s ratings, which he says he may change. The rating tables are images, so this site quotes only the text.
Comments
Questions, corrections and what worked for you. Upvote comments you find useful.
Loading comments…