Why a furnace
A furnace with a controller is a preferred way of heat treating and is said to give consistent results every time. That is a claim, not a measurement, but the logic is plain. A controller holds a setpoint, so a blade that reached a temperature last time reaches it again.
Controller and blade are not the same thing. A display is a setpoint, not proof that the whole blade has reached it. The routes here start the soak timer after the steel has equalised, not when the door closes.
Evenness
The temperature is usually somewhat different at the ends of the furnace, especially right next to the door. Keep blades away from the door and the walls. One furnace was measured in detail, and those numbers are that furnace's, so measure yours rather than assume.
Tempering
A regular furnace "can also be used for tempering but they aren't 'tuned' and calibrated for low temperature." A conventional oven works, "though the temperature will be more variable." Either way, check the temperature against a good thermometer.
What the stainless steels add
AEB-L and MagnaCut need a furnace that holds high, stable temperatures: the routes here run to 1066°C (1950°F) and 1121°C (2050°F). They also need foil or an atmosphere rated for that heat, quench plates, and for AEB-L a managed cold treatment. Plan the whole bench before you buy the bar.
Where this comes from
- Introduction to Knife Steel Heat Treating from a Metallurgist, Knife Steel Nerds. The stages, equipment, datasheets and what to do when datasheets disagree. Larrin Thomas’s own recommendations; it gives no schedule for a particular steel.
- How Even is an EvenHeat? How to Operate Furnaces Effectively, Knife Steel Nerds. One furnace, one set-up, measured. The numbers are that furnace’s; other furnaces will differ.
- How to Use a Steel Datasheet to Develop a Heat Treatment, Knife Steel Nerds. Reading a producer datasheet: soak, temper and temperature choices. Larrin Thomas’s recommendations, not a standard.
Comments
Questions, corrections and what worked for you. Upvote comments you find useful.
Loading comments…