About the petty
This base profile has a low heel and a fine point. Think about whether you want to use it mostly in the hand or on the board, because that changes what you will want from the grip and knuckle clearance.
I would spend a little time on the handle proportions here. On a small blade, the grip is a large part of how the whole knife feels, even when the outline looks quite simple.
This template
The gyuto's proportions at a smaller scale, with a low heel and the same gradual rise to the tip.
| Blade length | Heel height | Overall length | Prints on |
|---|---|---|---|
| 135 mm | 30 mm | 225 mm | 1 A4 sheet 1 Letter sheet |
Files and editing
- Ready to print
- Actual-size A4 and US Letter PDFs for each size, with a 100 mm ruler and labelled seam lines when the drawing spans more than one sheet.
- Editable profile
- Open any size in the editor to adjust the outline, tang, holes and dimensions. No account needed.
- More output formats
- Use the editor for PDF, SVG and DXF export, other paper sizes, and a design file you can reopen later.
Printing it
Print at 100% or Actual size, never Fit to page, and measure the 100 mm ruler on the sheet before you cut anything. The print guide has the details.
Changing it
If it is not quite the knife you have in mind, open it in the editor. You can type exact sizes or drag the outline, swap the tang, add pin holes and a bevel line, then print it or export a PDF, SVG or DXF. No account needed.
Creator and use
Free to download and edit. The site terms apply to the service and its templates.
Steel and heat treating
The outline is where a build starts. How the knife performs comes from the steel and what you do to it, so I would settle both before cutting anything. Which steel should your knife be? narrows the choice by your equipment and the knife, and heat treating takes each stage in order.
Made from this template
See makers’ finished knives, photos and build notes in the project gallery for this template.
Questions about the petty
Ask about this template, or read what others have asked, in the forum.